Tube bender

So I managed to get the discs on (only getting a wee spot of grease on the rotor and pads ... sheesh, thank goodness for iso-propyl alcohol). I got the steerer of the Pace forks cut, and filed and a star fangled nut fitted and then using the king headset spacers, arrived at a good handlebar height.

From there it was all about the 3/16" stainless steel tubes and a tube bender. Photos will follow, but I currently have a nice run with one bend directly to the front caliper, awaiting the Nokon top section from brake lever. The rear was a bit more complex. There are 2 guides for hose on the left seatstay, so i had to employ an s bend at the bottom to route directly into the caliper and then a very slight bend at the top (at 90 degrees, to follow the angle of the seatstay as it moves toward the seat tube). This will then accept a small Nokon section from the rearward cable stop on the top tube, with cable and the Nokon liner until i use another Nokon loop at the front to the rear brake lever.

It should (a-ha-ha) all look neat and tidy and work powerfully and be relatively impervious to dirt ingress. Should be. I *may* have made the bends a bit tight, and as such the brakes *may* be a little stiff. Fingers crossed.

The only bit I'm pretty sure I am not happy with is the top section of the rear brakes s bend. It is a little angular, not smooth, gentle and radiused like I wanted. May alter it, we'll see.